Instructions Of Interior Painting

Interior painting requires the same careful surface treatment as exterior painting. With the advent of odorless paints, it has become possible to paint at any time of the year. In the olden days, most interior colors in the house were done in the fall or spring, when the windows could be left open to ventilate the room. However, the open windows brought dust into the room and ruined the finished painted surface.
Good interior paint usually consists of 50% prep and 50% paint. Do not rush to prepare the surface looking for a brush or roller. If the surface is not properly prepared, it will come back with a brush or roller after a few months.
This section provides the information you need to apply different types of paint to different interior wall, ceiling and floor materials. Visit:- https://www.schadeherstelproducten.nl/
throw

New dry plaster in good condition, which needs to be finished with a paint other than water-based paint, should be sealed with a layer of primer, dried and then checked for a uniform appearance. The difference in gloss and color of the tinting primer indicates whether the entire surface is completely sealed. If not, you need to apply a second coat of primer sealer. If only a few “suction points” are observed, a second layer in these areas may be sufficient.
Flat, semi-glossy or high-gloss finishes can be applied to primed surfaces. For a smooth finish, apply flat wall paint twice after the first coat. For a semi-gloss finish, apply flat-wall paint and semi-gloss paint to the primed surface. For a high-gloss finish, use a semi-gloss paint coat and a high-gloss enamel coat over the primer.
Before applying the calsimin-type watercolor to the new plaster wall, it must be glued with glue-water glue or, if the plaster is dry, with a fine varnish or primer sealer.
Casein-type paints can be applied directly to the surface of the plaster, or a primer sealer layer can be applied to the surface first to even out the effects of non-uniform suction. The same is true for resin emulsion paints, but this definitely prefers the manufacturer’s recommendations. Emulsion resin paints usually only need to be applied to completely dry plaster, as the binder usually contains a small amount of oil. Textured wall paint can also be used on drywall surfaces. The advantage of this type of paint is that a single coat economically provides textured decoration and alleviates the monotony of smooth, flat paint. It also covers plaster cracks and bandages more completely than regular wall paints. The disadvantage of textured wall paint is that it collects dust and is difficult to repair for a smooth finish. These materials can be used as oil or oil paint, thicker than regular wall paint, and can be applied to wall panels and plaster to create texture effects such as random, Spanish, mission, and multicolor. .. Composition wall panel

Composition wall panels usually do not have any special painting problems if you take the usual precautions, such as making sure the surface is dry and free of grease and oil. The procedure for painting plaster is the same as for plaster. A primer and sealant coating is required, followed by the desired finish. Alternatively, you can apply a flat paint or a coat of resin emulsion.
wallpaper

Water-diluted paint can be applied to wallpaper that does not contain dyes that adhere well to the wall and can penetrate the paint. It is recommended to use thick wallpaper to apply the paint. Other paints that are not diluted with water can also be applied to the wallpaper by following the instructions for plastering. However, such paint-covered backgrounds are difficult to remove without damaging the plaster.
Wooden walls and finish

New interior walls and wood finishes should be sanded and dusted before painting or repainting. To protect the grain, the surface can be rubbed with flaxseed oil, varnished or waxed. If you need an opaque finish, you can dilute the semi-glossy paint with 1 pint of turpentine oil per liter of paint, or use the wall primer sealant above as a wood primer. Then apply a semi-gloss paint once or twice on top of the completely dry primer. If you want a glossy finish, the final coat should be a high-gloss enamel.

Leave a comment

Your email address will not be published. Required fields are marked *